On the Internet you can find them in all shapes and sizes: circuits to test remote controls. Here I describe a simple and cheap method that is not that well-known.
This method is based on the principle that an LED does not only generate light when you apply a voltage to it, but also works in the opposite direction to generate a voltage when light falls on it. Within constraints it can therefore be used as an alternative for a proper phototransistor or photodiode. The major advantage is that you will usually have an LED around somewhere, which may not be true for a photodiode.
This is also true for infrared (IR) diodes and this makes them eminently suitable for testing a remote control. You only need to connect a voltmeter to the IR diode and the remote control tester is finished. Set the multimeter so it measures DC voltage and turn it on. Hold the remote control close to the IR diode and push any button. If the remote control is working then the voltage shown on the display will quickly rise. When you release the button the voltage will drop again.
However, don’t expect a very high voltage from the IR diode! The voltage generated by the diode will only be about 300 mV, but this is sufficient to show whether the remote control is working or not. There are quite a few other objects that emit IR radiation. So, first note the voltage indicated by the voltmeter before pushing any of the buttons on the remote control and use this as a reference value. Also, don’t do this test in a well lit room or a room with the sun shining in, because there is the chance that there is too much IR radiation present.
To quickly reduce the diode voltage to zero before doing the next measurement you can short-circuit the pins of the diode briefly. This will not damage the diode.—Tom van Steenkiste, Elektor, 11/2010
Want tips about testing power supplies? We’ve got you covered! EE Tip #112 will help you determine the stability of your lab or bench-top supply!