iWave Systems has partnered with SoC-e for enabling HSR/PRP IP on iWave’s Zynq 7000 SoC SOM Module. iWave has rigorously validated SoC-e’s High-availability Seamless Redundancy (HSR) and Parallel Redundancy Protocol (PRP) IP Protocol on our Zynq 7000 SoC based SOM module. iWave’s Zynq 7000 SoC SOM and SoC-e’s HSR/PRP Switch IP Core reduce the time-to-market and simplifying design complexity. SOC-e develops IP portfolios for leading-edge networking and synchronization technologies for time critical systems.
The Zynq-7000 programmable SoC family integrates the software programmability of an Arm-based processor with the hardware programmability of an FPGA, enabling key analytics and hardware acceleration while integrating CPU, DSP, ASSP and mixed signal functionality on a single device. The iW-RainboW-G28M (Zynq 7000 Board) is a featured-full and ready to-operate embedded software and advanced circuit development kit built around the smallest member from the Xilinx Zynq-7000 family, the Z-7010.
The Zynq-7000 SOM / Development Kit is based on the Xilinx All Programmable System-on-Chip architecture, which firmly incorporates a single / Dual Cortex A9 with Xilinx 7-series FPGA logic. At the point when combined with the rich set of media and connectivity peripherals accessible on the Zynq 7000 SOM, the Zynq Z-7007S, Z-7014S, Z-7010, Z-7020, can host an entire design system.
Memories, 512 MB DDR3 (Expandable to 1 GB) or 512 MB NAND Flash (Expandable), that are on-board, video and sound I/O, USB 2.0 OTG, Gigabit Ethernet and SD (4-bit) will have your board up-and-running with no extra hardware required. Moreover, PMIC with RTC bolster connectors is accessible to put any design on a simple development way.
The iW-RainboW-G28M gives an ultra-cost to embedded designers that don’t require the high-thickness I/O of the FMC connector yet at the same time wish to use the enormous preparing force and extensibility of the Zynq AP SoC architecture.
iWave Systems | www.iwavesystems.com